BC205XLT.4 TOOLS REQUIRED: Small Phillips screwdriver, small wire cutters. 1. Slide off the battery pack and remove the antenna from the scanner. 2. Using a small Phillips screwdriver, remove the two screws from the back of the scanner, the two screws which hold the battery retaining spring at the base and the spring itself. 3. Carefully pry the bottom of the rear cover from the radio and remove the cover. 4. Locate the two small screws at the base of the circuit board and remove them. Gently pull the front panel from the mainframe at the base and separate them. 5. Locate the (64 pin quad flatpack) microprocessor IC labelled "UNIDEN UC-1147" and the 10k ohm (brown-black-orange) leadless resistor positioned above the letters "DEN" on the IC. 6. Using miniature wire cutters, cut the resistor body in two without disturbing anything else near it. If the left solder pad comes loose, it may be peeled from the board. Brush or blow away any residue. This completes the restoration. continued in file bc205xlt.2