FT727R.2 Key Codes: CAT Control consists of duplication the keystrokes that can be made on the tranceiver keypad by sending the corresponding keycodes to the Serial Keycode Input contact of the CAT jack. The most significant four bits (MSD) correspond with the key column and the least significant four bits (LSD) correspond with the key row. The Function key (on the side of the tranceiver) is simulated by setting bit 7. Results are identical to those described for manual operation in the FT-727R Operating Manual. Serial Meter Output is sent approximately every 100 ms while receiving. [Table for the codes. The lines in [] are the original values in the Yaesu handout, and are followed by the corrected lines as determined by KB7ABA. Remove the lines in [] to see what should be the right table.] [ @ FUNC F E D C B ] @ FUNC 8 9 A B C MSD @ [ @ NORM 7 6 5 4 3 ] @ NORM 0 1 2 3 4 LSD V E +RPT SIMP -RPT PMS P SET 1 2 3 V c D SAV-T T-DEC T-SET TX-M S/CH 4 5 6 M MR B SAVE T-ENC SCAN MC Shift 7 8 9 C <=> 7 LOCK BATT BEEP DUP Step * 0 # V/U D