IC24AT.3 AM AIRCRAFT RECEIVE PLUS 740 to 960 MHz RECEIVE Remove D13 from the main logic board (this diode may already be removed by ICOM in some units). This diode may already be removed in some radios. D13 is on the main logic board and is a discreet diode (one of the two in the radio) near the center of the board. It is the left discreet diode of the two on the board when the radio is open and held with the controls away from you. Simultaneously hold "Light", "B", and "#" keys depressed and turn power on. It is important to note that the radio will not meet specifica- tion on the out of band receive frequencies that are enabled with this modification. DIRECT KEYBOARD ENTRY of 100 MHz FREQUENCY Simultaneously hold "Light" and "3" keys depressed and turn power on. CROSS BAND REPEAT (simplex) Remove D14 from the main logic board (tiis diode may already be removed by ICOM in some units). The diode is a discreet diode to the right of D13 (from above) and directly beside it. Simultaneously hold "Funct" depressed and push "C". To turn on cross band repeat: Hold "Funct" depressed then push "5" and then push "D". To turn off cross band repeat simultaneously hold "Funct" and "D" depressed. %*********************** NOTE: I haven't tested these, proceed at your own risk! WA2ISE ------------------------ A notice found on a piece of test equipment made in Japan: "IT PUT ON THE VINYL SHEET ON THE SURFACE OF UPPER & LOWER PANEL FOR THE PROTECTION PLEASE USE AFTER TEAR OFF VINYL SHEET WHEN USING.