ICCIIV.5 - 5 - 05 Set frequency. The data format is given above. If the data contains fewer digits than the rig uses, the digits sent will be changed and the rest will remain within its tuning range, it responds with a packet con- taining the d If it didn't like the data, it responds with the data "FA": These acknowledgement codes are used by all following commands. cy data by sending the "FA" acknowledgement and: 1) If the quency data that is more than 30 MHzne byte is sent, it sets the mode per the above table. If tw 07 Set VFO status. If no data is sent, the rig changes from MEMORY mode to VFO mode. If data 00 or 01 is sent, the 08 Set memory channel. If no data is sent, the rig changes from VFO mode to MEMORY mode. If BCD channel data is sent, the rig changes to that memory channel. 09 Store displayed frequency and mode into displayed memory channel. No dat to a VFO. No data required. I will give a few examples of codes and responses for the 735. The 735 is at address 04 and the computer nnel, and code 03 to read the frequency). Assume the 735 has the frequency 7.12750 MHz stored in memory #1. CONTINUED IN FILE ICCIIV.6 - REQUEST FROM SERVER