ICR7000.3 Long live tinkering! Jack Albert, WA9FVP, reports that he tried a modification, and it works! Jack doesn't have the remote control option in his R7000, so he elected to use the front panel REMOTE switch as a bank switch. He installed a 48,000 ohm resistor between IC8 pin 19 and ground, and ran a wire from the REMOTE switch to pin 19. When you switch between banks, you must also rotate the channel selector knob, forcing to the microprocessor to read from memory. A word of warning: If the remote switch is used to directly select the new bank, you will be placing 13.8V on pin 19 of IC8, which is too high. Instead, make a voltage divider by putting a 68k resistor between the output of the remote switch and pin 19, and a 39k resistor between pin 19 and ground. Bob Morrow