R7000.12

  Also from IC-8 pin 19, run a long wire to the front of the unit.
This wire will be connected to a switch that can be mounted to the
bottom cover.  Resolder the lithium battery lead that was disconnected
and reinstall the control board and the partition above it.

  Looking at the bottom cover, you will see two holes near the front.
The hole closest to the edge is used to adjust the drag on the tuning
knob.  The next hole in from the edge is the one you want.  Mount a
small SPST switch in this hole.  I used a small plug and mating
connector to make the connections between the switch and the logic
board.  The long wire that you connected to IC-8 pin 19 goes to one
side of the switch and a wire to a ground point goes to the other
switch connection.  I used one of the mounting screws that hold the
remote control board for my ground lead.

  When you have finished, you will have a second switch selectable
bank of memory channels.  This also means that you can program in
one pair of search limits for each of the two banks of memory.

Rich ( K2QG )