TM231A.3

    WHAT NEEDS TO BE DONE, IS TO SOLDER A DIODE TO THE PADS LOCATED UNDER
THE TONE SWITCH. (S205)  THIS IS D209 ON THE SCHEMATIC. YOU WILL PROBABLY 
NOTICE HOW SMALL AND HOW THINLY SPACED THE PADS ARE, AND YOU WILL BE WONDERING
HOW THAT BIG DIODE IS GOING TO  FIT!...
   2) MAKING THE MOD --YOU WILL HAVE TO FABRICATE YOUR OWN SMT DIODE. 
DO THIS BY BENDING THE LEADS OF THE DIODE UNDER THE BODY AND CLIPPING THE
REMAINING LEAD LENGTHS SO THAT SPACE BETWEEN THE LEADS ARE EQUAL TO THE 
SPACING OF PADS ON THE BOARD. THE DIODE MUST BE POSITIONED SO THAT THE 
CATHODE IS POINTING DOWN, TOWORD THE CPU CHIP.   THIS IS VERY IMPORTANT.
   3) RESET THE CPU. PRESS THE MR BUTTON AND TURN THE RADIO ON.
  THAT'S IT, JUST CONNECT POWER, ANTENNA AND THE MICROPHONE.  TURNING ON
THE POWER WILL RESET THE RADIO ERASING ALL MEMORIES.  OH WELL...
                        GOOD LUCK AND 73,
                       PAUL SAFFREN --- N6NHH
                       @KI6EH
----- END OF MESSAGE 23471 FROM WP4XQ @ WP4XQ.PR.USA.NA -----
                           IC-3200A FIX

sysop note:  Had to break this in two messages.  Original too long.
W2TKU@W2TKU-Sarasota,FL