TM241A

OUT OF BAND MOD

1. DISCONNECT THE POWER AND ANT.
2. REMOVE TOP AND BOTTOM COVER.
3. REMOVE ALL KNOBS FROM FROUNT PANEL.
4. REMOVE THE NUT FROM THE MIKE JACK AND NUT FROM CHANNEL SWITCH.
5. REMOVE THE 4 SCREWS HOLDING FROUNT PANEL.
6. REMOVE THE 3 SCREWS FROM CONTROL BOARD.
7. LOCATE THE GREEN JUMPER WIRE ON CRONTAL BOARD, CUT AND TAPE OFF.
8. INSTALL CHIP DIODE D 209 ON CONTROL BOARD PART # MA141A
9. REASSEMBLE RADIO.
10. RESET MICROPROSSOR (PRESS AND HOLD [MR] WHILE TURNING ON POWER.