ts790.1 13 PIN DIN PLUG CONFIGURATION. 1 Using a small flat blade screwdriver,lift up on the tab of the nylon cover. 2 Once the tab clears the slot of the metal holder,pull the cover off the plug. 3 Carefully separate the two metal holders and remove the pin assembly. 4 First tin pins 1,8 and 11 of the assembly so the resistors can easily be soldered in place. 5 SOLDER A 100K ohm,1/4 watt resistor between pins be cut and shaped before soldering). 6 Solder a 1.5K ohm,1/4 watt resistor between pin 8 and the lead of the 100K ohm resistor that is attached to pin 11.(the resistor leads should be cut and shaped before soldering) 7 Wrap a small piece of electrical tape around the resistors.This will insulate them from the metal holder after the plug is assembled. 8 Mount the pin assembly in the two metal holders. 9 Slide the cover over the plug until the tab engages in the slot. The "U" shaped strain relief will not be used. 10 Plug the 13 pin din plug in the ACC2 jack on the back panel of the radio. continued in ts790.2